2014 DUTCH DESIGN WEEK

2 thoughts on “2014 DUTCH DESIGN WEEK”

1. 

   Yudhie says:

   If it can be printed, I’m sure you can also do it with an Ultimaker. The great part about it is that it would be polbisse with fewer parts than with most 3D printers. Because the build volume is bigger you don’t need to split the model as much. With PLA the props might be a bit brittle. I think ABS with a good support structure would be flexible and still strong. This would be a challenging print, but definitely polbisse.

   February 28, 2016 at 1:21 pm

   Reply
2. 

   corburterilio says:

   Regards for all your efforts that you have put in this. very interesting information.

   September 23, 2016 at 5:27 pm

   Reply