2 thoughts on “2014 DUTCH DESIGN WEEK

  1. Yudhie says:

    If it can be printed, I’m sure you can also do it with an Ultimaker. The great part about it is that it would be polbisse with fewer parts than with most 3D printers. Because the build volume is bigger you don’t need to split the model as much. With PLA the props might be a bit brittle. I think ABS with a good support structure would be flexible and still strong. This would be a challenging print, but definitely polbisse.

Leave a Reply to corburterilio Cancel reply

Your email address will not be published. Required fields are marked *